Adding a static route

You must configure a default route for the SD-WAN. The default gateways for each SD-WAN member interface do not need to be defined in the static routes table. FortiGate will decide what route or routes are preferred using Equal Cost Multi-Path (ECMP) based on distance and priority.

To create a static route for SD-WAN:
  1. Go to Network > Static Routes.
  2. Click Create New. The New Static Route page opens.
  3. Set Destination to Subnet, and leave the IP address and subnet mask as
  4. In the Interface field select an SD-WAN zone.

  5. Ensure that Status is Enabled.
  6. Click OK.

Next: Selecting the implicit SD-WAN algorithm