Fixed port

Some network configurations do not operate correctly if a NAT policy translates the source port of packets used by the connection. NAT translates source ports to keep track of connections for a particular service.

From the CLI you can enable fixedport when configuring a security policy for NAT policies to prevent source port translation.

config firewall policy

edit <policy-id>

...

set fixedport enable

...

end

However, enabling fixedport means that only one connection can be supported through the firewall for this service. To be able to support multiple connections, add an IP pool, and then select Dynamic IP pool in the policy. The firewall randomly selects an IP address from the IP pool and assigns it to each connection. In this case, the number of connections that the firewall can support is limited by the number of IP addresses in the pool.