WiFi LAN configuration
When working with a FortiGate WiFi controller, you can configure your wireless network before you install any access points. If you are working with a standalone FortiWiFi unit, the access point hardware is already present but the configuration is quite similar. Both are covered in this section.
|
|
On FortiGate model 30D, GUI configuration of the WiFi controller is disabled by default. To enable it, enter the following CLI commands:
|
|
|
The WiFi Controller and Switch Controller are enabled through the Feature Store (under System > Feature Select). However, they are separately enabled and configured to display in the GUI via the CLI. To enable both WiFi and Switch controllers, enter the following CLI commands::
To enable the GUI display for both controllers, enter the following CLI commands::
|
If you want to connect and authorize external APs, such as FortiAP units, see the next section, Access point deployment.