firewall shaper per-ip-shaper

Use this command to configure traffic shaping that is applied per IP address, instead of per policy or per shaper. As with the shared traffic shaper, you select per-IP traffic shapers in firewall policies.

config firewall shaper per-ip-shaper
    edit {name}
    # Configure per-IP traffic shaper.
        set name {string}   Traffic shaper name. size[35]
        set max-bandwidth {integer}   Upper bandwidth limit enforced by this shaper (0 - 16776000). 0 means no limit. Units depend on the bandwidth-unit setting. range[0-16776000]
        set bandwidth-unit {kbps | mbps | gbps}   Unit of measurement for maximum bandwidth for this shaper (Kbps, Mbps or Gbps).
                kbps  Kilobits per second.
                mbps  Megabits per second.
                gbps  Gigabits per second.
        set max-concurrent-session {integer}   Maximum number of concurrent sessions allowed by this shaper (0 - 2097000). 0 means no limit. range[0-2097000]
        set diffserv-forward {enable | disable}   Enable/disable changing the Forward (original) DiffServ setting applied to traffic accepted by this shaper.
        set diffserv-reverse {enable | disable}   Enable/disable changing the Reverse (reply) DiffServ setting applied to traffic accepted by this shaper.
        set diffservcode-forward {string}   Forward (original) DiffServ setting to be applied to traffic accepted by this shaper.
        set diffservcode-rev {string}   Reverse (reply) DiffServ setting to be applied to traffic accepted by this shaper.
    next
end

Additional information

The following section is for those options that require additional explanation.