system dnp3-proxy

Note: This command is only available for FortiGate Rugged platforms.

Use this command to configure support for Distributed Network Protocol for FortiGate Rugged platforms.

config system dnp3-proxy
    set port {integer}   DNP3 TCPServer Port. range[1-65535]
    set term-baudrate {integer}   Term Baudrate. range[0-4294967295]
    set term-databits {integer}   Term Data Bits. range[0-65535]
    set term-stopbits {integer}   Term Stop Bits. range[0-65535]
    set term-parity {none | odd | even}   Term Parity
            none  No parity check.
            odd   Odd parity check.
            even  Even parity check.
    set term-flowcontrol {none | xon_xoff | hardware}   Term Flow Control
            none      No flow control.
            xon_xoff  Enable software flow control on both input and output.
            hardware  Enable hardware flow control.
end