firewall ip-translation
Use this command to configure IP address translation.
config firewall ip-translation edit {transid} # Configure firewall IP-translation. set transid {integer} IP translation ID. range[0-4294967295] set type {SCTP} IP translation type (option: SCTP). SCTP SCTP set startip {ipv4 address any} First IPv4 address (inclusive) in the range of the addresses to be translated (format xxx.xxx.xxx.xxx, default: 0.0.0.0). set endip {ipv4 address any} Final IPv4 address (inclusive) in the range of the addresses to be translated (format xxx.xxx.xxx.xxx, default: 0.0.0.0). set map-startip {ipv4 address any} Address to be used as the starting point for translation in the range (format xxx.xxx.xxx.xxx, default: 0.0.0.0). next end
Additional information
The following section is for those options that require additional explanation.