switch-controller lldp-settings
Use this command to enable or disable and configure LLDP global settings.
config switch-controller lldp-settings set status {enable | disable} Enable/disable LLDP global settings. set tx-hold {integer} Number of tx-intervals before local LLDP data expires (1 - 16, default = 4). Packet TTL is tx-hold * tx-interval. range[1-16] set tx-interval {integer} Frequency of LLDP PDU transmission from FortiSwitch (5 - 4095 sec, default = 30). Packet TTL is tx-hold * tx-interval. range[5-4095] set fast-start-interval {integer} Frequency of LLDP PDU transmission from FortiSwitch for the first 4 packets when the link is up (2 - 5 sec, default = 2, 0 = disable fast start). range[0-255] set management-interface {internal | mgmt} Primary management interface to be advertised in LLDP and CDP PDUs. internal Use internal interface. mgmt Use management interface. end
Additional information
The following section is for those options that require additional explanation.
tx-hold
Number of tx-intervals before the local LLDP data expires. Therefore, the packet TTL (in seconds) is tx-hold times tx-interval. The range for txhold is 1 to 16, and the default value is 4.
tx-interval
How often the FortiSwitch transmits the LLDP PDU. The range is 5 to 4095 seconds, and the default is 30 seconds.
fast-start-interval
How often the FortiSwitch transmits the first 4 LLDP packets when a link comes up. The range is 2 to 5 seconds, and the default is 2 seconds. Set this variable to zero to disable fast start.
management-interface
Primary management interface to be advertised in LLDP and CDP PDUs.