system wireless settings

Use this command to configure wireless settings.

config system wireless settings
    set mode {CLIENT | AP | SCAN}   Mode.
            CLIENT  Client.
            AP      Access point.
            SCAN    Scan.
    set band {option}   Band.
            802.11a          802.11a.
            802.11b          802.11b.
            802.11g          802.11g.
            802.11g-only     802.11g only.
            802.11n          802.11n at 2.4G band.
            802.11ng-only    802.11ng only at 2.4G band.
            802.11n-only     802.11n only at 2.4G band.
            802.11n-5G       802.11n at 5G band.
            802.11n-5G-only  802.11n only at 5G band.
            802.11ac         802.11ac at 5G band.
            802.11acn-only   802.11acn only at 5G band.
            802.11ac-only    802.11ac only at 5G band.
    set geography {option}   Geography.
            World     World.
            Americas  Americas.
            EMEA      EMEA.
            Israel    Israel.
            Japan     Japan.
    set channel {integer}   Channel. range[0-4294967295]
    set power-level {integer}   Power level (0 - 17). range[0-17]
    set beacon-interval {integer}   Beacon level (25 - 1000). range[25-1000]
    set short-guard-interval {enable | disable}   Enable/disable short guard interval.
    set channel-bonding {enable | disable}   Supported channel width.
    set bgscan {disable | enable}   Enable/disable background rogue AP scan.
    set bgscan-interval {integer}   Interval between two rounds of scanning (15 - 3600 sec). range[15-3600]
    set bgscan-idle {integer}   Interval between scanning channels (100 - 1000 ms). range[100-1000]
    set rogue-scan {enable | disable}   Enable/disable rogue scan.
    set rogue-scan-mac-adjacency {integer}   MAC adjacency (0-31). range[0-31]
end