Extend SCTP filtering capabilities 7.0.1

A Stream Control Transmission Protocol (SCTP) dissector and Payload Protocol Identifier (PPID) filter can be used to either terminate the SCTP session, or replace the offending data chunk with zeros to keep the client and server sequence numbers synchronized. The SCTP filter action can also pass the data chunk.

To configure and test an SCTP filter:

1. Configure an SCTP filter profile that uses the reset action:

   config sctp-filter profile
       edit "sctp"
           set comment "Demo profile"
           config ppid-filters
               edit 1
                   set ppid 112233
                   set action reset
                   set comment "test chunk"
               next
           end
       next
   end

2. Use the SCTP filter profile in a firewall policy:

   config firewall policy
       edit 1
           set name "1"
           set srcintf "port38"
           set dstintf "port37"
           set srcaddr "all"
           set dstaddr "all"
           set action accept
           set schedule "always"
           set service "ALL"
           set utm-status enable
           set ssl-ssh-profile "new-deep-inspection"
           set sctp-filter-profile "sctp"
           set logtraffic all
       next
   end

3. On the SCTP client, confirm that the connection works and send a data chunk with PPID 112233.

   

4. The IPS engine detects the data chunk. The PPID matches the PPID filter, and the filter action is reset, so the data chunk is not received on the server, and the session is terminated.

   

5. Change the filter action to replace:

   config sctp-filter profile
       edit "sctp"
           config ppid-filters
               edit 1
                   set action replace
               next
           end
       next
   end

6. Resend the data chunk.

7. The IPS engine detects the data chunk. The PPID matches the PPID filter, and the filter action is replace, so the data chunk is replaced with zeros.