Fortinet Document Library

Version:


Table of Contents

Cookbook

6.2.0
Download PDF
Copy Link

MSTI support

Administrators can control multiple spanning tree instances (MSTI) one to 14, and allocate VLANs to specific instances. VLANs that are not added to a specific interface are in MSTI-0. FortiLink controls MSTI-0 (CST) and MSTI-15 for FortiLink management (VLAN 4094).

Each instance is a full and complete spanning tree. Any VLAN can be mapped to any instance, allowing the trees to have different topologies for each MSTI. Various parameters can be configured in each instance, such as cost and priority.

To configure MSTI support:
  1. Create a spanning tree protocol (STP) instance between 1 to 14:
    config switch-controller  stp-instance 
        edit 1
            set vlan-range tenant-vlan3 vsw.aggr1 
        next
    end
  2. Configure a specific STP priority on different managed FortiSwitch units:
    config switch-controller managed-switch 
        edit S248EPTF1800XXXX
            config stp-instance 
                edit 1
                    set priority  8192
                next
            end
        next
    end

MSTI support

Administrators can control multiple spanning tree instances (MSTI) one to 14, and allocate VLANs to specific instances. VLANs that are not added to a specific interface are in MSTI-0. FortiLink controls MSTI-0 (CST) and MSTI-15 for FortiLink management (VLAN 4094).

Each instance is a full and complete spanning tree. Any VLAN can be mapped to any instance, allowing the trees to have different topologies for each MSTI. Various parameters can be configured in each instance, such as cost and priority.

To configure MSTI support:
  1. Create a spanning tree protocol (STP) instance between 1 to 14:
    config switch-controller  stp-instance 
        edit 1
            set vlan-range tenant-vlan3 vsw.aggr1 
        next
    end
  2. Configure a specific STP priority on different managed FortiSwitch units:
    config switch-controller managed-switch 
        edit S248EPTF1800XXXX
            config stp-instance 
                edit 1
                    set priority  8192
                next
            end
        next
    end