Replace a device using the same IP address

When adding a switch or router that will use the same IP address as the original device modeled in Inventory, the original model must be deleted from the database and a new model added. This ensures all internal mappings and other related files associated to that model are correct for the new device. Otherwise, unexpected behavior occurs.

Note: Deleting the model from FortiNAC removes all manual switch device and port groupings done on the switch model.

1. Review the model of the device to be replaced. Note or take screen captures of all configurations, including port and device group memberships. They will need to be re-entered later.
2. Ensure the new device is configured appropriately.
3. Once original device is decommissioned, delete the old device model. See Delete a device.
4. Once the new device is on the network, add to Inventory using the appropriate credentials. See Add or modify a device.
5. Configure device model using the settings recorded previously.