FortiNAC

A FortiNAC device can be added to the Security Fabric on the root FortiGate. After the device has been added and authorized, you can log in to the FortiNAC from the FortiGate topology views.

Adding a FortiNAC to the Security Fabric requires a FortiNAC with a license issued in the year 2020 or later that includes an additional certificate. The device cannot be added if it has an older license. Use the licensetool in the FortiNAC CLI to determine if your license includes the additional certificate.

To add a FortiNAC to the Security Fabric:

1. On the FortNAC, configure telemetry and input the IP address of the root FortiGate. See Security Fabric Connection in the FortiNAC Administration Guide for more information.
2. On the root FortiGate, authorize the FortiNAC.
3. Verify the connection status in the topology views.

To authorize the FortiNAC on the root FortiGate in the GUI:

1. Go to Security Fabric > Fabric Connectors.
2. The FortiNAC device will be highlighted in the topology list in the right panel with the status Waiting for Authorization.
3. Click on the highlighted FortiNAC and select Authorize.

   

   Optionally, you can also deny authorization to the FortiNAC to remove it from the list.

To authorize the FortiNAC on the root FortiGate in the CLI:

config system csf
    config trusted-list
        edit "FNVMCATM20000306"
            set action accept
        next
    end
end

To verify the connection status:

1. After the FortiNAC is authorized, go to Security Fabric > Physical Topology and confirm that it is included in the topology.

   

2. Go to Security Fabric > Logical Topology and confirm the FortiNAC is also displayed there.

   

3. Run the following command in the CLI to view information about the FortiNAC device's status:

   # diagnose sys csf downstream-devices fortinac 
   {
     "path":"FG5H1E5818900126:FNVMCATM20000306",
     "mgmt_ip_str":"10.1.100.197",
     "mgmt_port":0,
     "admin_port":8443,
     "serial":"FNVMCATM20000306",
     "host_name":"adnac",
     "device_type":"fortinac",
     "upstream_intf":"port2",
     "upstream_serial":"FG5H1E5818900126",
     "is_discovered":true,
     "ip_str":"10.1.100.197",
     "downstream_intf":"eth0",
     "authorizer":"FG5H1E5818900126",
     "idx":1
   }

To log in to the FortiNAC from the FortiGate:

1. On the FortiGate, go to Security Fabric > Physical Topology or Security Fabric > Logical Topology.
2. Click on the FortiNAC and select Login to <serial_number>.

   

   A new tab will open to the FortiNAC log in page.

3. Enter the username and password to log in to the FortiNAC.