Set up FortiToken multi-factor authentication

This configuration adds multi-factor authentication (MFA) to the split tunnel configuration (SSL VPN split tunnel for remote user). It uses one of the two free mobile FortiTokens that is already installed on the FortiGate.

To configure MFA using the GUI:

1. Configure a user and user group.
   1. Go to User & Authentication > User Definition and edit local user sslvpnuser1.
   2. Enter the user's Email Address.
   3. Enable Two-factor Authentication and select one mobile Token from the list,
   4. Enable Send Activation Code and select Email.
   5. Click Next and click Submit.
2. Activate the mobile token.
   1. When a FortiToken is added to user sslvpnuser1, an email is sent to the user's email address. Follow the instructions to install your FortiToken mobile application on your device and activate your token.

To configure MFA using the CLI:

1. Configure a user and user group.

   config user local
       edit "sslvpnuser1"
           set type password
           set two-factor fortitoken
           set fortitoken <select mobile token for the option list>
           set email-to <user's email address>
           set passwd <user's password>
       next
   end
   config user group
       edit "sslvpngroup" 
           set member "sslvpnuser1"
       next 
   end

2. Activate the mobile token.
   1. When a FortiToken is added to user sslvpnuser1, an email is sent to the user's email address. Follow the instructions to install your FortiToken mobile application on your device and activate your token.