Manage and configure your OnSight vCollector
This page is only applicable to OnSight versions 2020.51 and later.
The OnSight comes bundled with a set of CLI commands to manage and configure the OnSight. The commands utilize the following structure:
onsight [OPTIONS] COMMAND [ARGS]
To see the available commands, run:
onsight --help
Management and configuration commands
The available OnSight management and configuration commands are described in the following table:
Command |
Use this to |
---|---|
check-upgrade |
Check to see if a newer vCollector is available |
configure-vcollector |
where [OPTIONS] are:
|
logs |
Retrieves the OnSight logs and adds them to a zip file locally. You also have the option to send the logs to our support team. To use this command, run:
where [OPTIONS] are:
Running the |
register |
Register a new OnSight and generate an appliance key. |
shell |
Open a shell connection to the collector. |
start-vcollector |
Start the OnSight vCollector container. |
status |
Get the current status of the OnSight and its components |
uninstall |
Uninstall the OnSight. |
upgrade |
Upgrade to the latest version of the OnSight vCollector. |
configure-ntp |
Configure the OnSight to use an internal NTP server. This command is only applicable to OnSight virtual image installations. To use this command, see NTP server configuration . |
ncm-uninstall | Uninstalls the NCM. Tis command is only applicable if you are using NCM. |