IPsec template enhanced support for tunnel interface configuration 7.0.1

IPSEC template enhanced support for tunnel interface configuration.

To configure an IPsec template:

1. Go to Device Manager > Provisioning Template > IPsec Tunnel Templates, and create or edit a template.
2. In the template, configure the IP address for an IPsec tunnel interface in Tunnel Interface Setup:
   • IP: Input the IP address, for example 10.10.1.1/32. Meta fields are also supported, for example 10.10.$(side_id).1/32.
   • Remote IP: Input the IP address or meta field for the remote IP.
     
3. Click OK to save the template.
4. Click Install Wizard at the top of the page to perform an installation.
   The Install Preview shows that FortiManager is pushing the IPsec VPN tunnel interface and its IP address to the device.