Fortinet black logo

Administration Guide

Enable normal mode

Enable normal mode

Normal mode can only be enabled or disabled from the CLI.

After changing the workspace mode, your session will end, and you will be required to log back in to the FortiManager.

To enable normal mode:
  1. Go to System Settings > Dashboard.
  2. In the CLI Console widget enter the following CLI commands in their entirety:

    config system global

    set workspace-mode normal

    end

When workspace-mode is normal, Device Manager and Policy & Objects are read-only. You must lock the ADOM, a device, or a policy package before you can make any changes.

Enable normal mode

Normal mode can only be enabled or disabled from the CLI.

After changing the workspace mode, your session will end, and you will be required to log back in to the FortiManager.

To enable normal mode:
  1. Go to System Settings > Dashboard.
  2. In the CLI Console widget enter the following CLI commands in their entirety:

    config system global

    set workspace-mode normal

    end

When workspace-mode is normal, Device Manager and Policy & Objects are read-only. You must lock the ADOM, a device, or a policy package before you can make any changes.