Neighbors
You can create SD-WAN rules that include Border Gateway Protocol (BGP) neighbors.
You must create BGP neighbors for FortiGate devices before you can add them to SD-WAN templates.
To configure BGP neighbors for SD-WAN templates:
- If using ADOMs, ensure that you are in the correct ADOM.
-
Go to Device Manager > Provisioning Templates > SD-WAN Templates.
- Double-click an SD-WAN template to open it for editing, or click Create New in the toolbar.
The SD-WAN template opens.
- In the Neighbor toolbar, click Create New.
The Create New Neighbor pane opens:
- Configure the following:
IP
Type the IP address for the BGP neighbor.
Interface Member
Click the box, and select interface members.
Multiple interface members can be selected for a neighbor. This allows the SD-WAN neighbor feature to support topologies where there are multiple SD-WAN overlays and/or underlays to a neighbor. When multiple interface members are selected, route failover will only occur if both tunnels to a neighbor are down.
Performance SLA
Click the list, and select the performance SLA.
Role
Select Standalone, Primary, or Secondary.
- Click OK.