Setting up Network IP configuration
Log in into the device from the console using the default username and password (admin/admin). Setup a new password and log in into the device using the new credentials.
- Configure IP - Run the
set interface ipv4command to configure the IPv4 address of the management network interface (IPv4 address), netmask, and gateway address.
- Configure FQDN - Run the
set system fqdncommand to configure the hostname. - Configure time zone - Run the
set system timezonecommand to interactively configure the time zone. - Configure date - Run the
set system datecommand to configure the date in the YYYY-MM-DD format. - Configure NTP - Run the
set system ntpcommand to configure the NTP server.