DHCPv6 stateful server

Similar to a DHCPv4 server, a DHCPv6 server is stateful. It can track client/server states, assign IP addresses to clients, and maintain full control over the process. In addition to assigning IP addresses, a DHCP server can also provide DNS server addresses. However, this IP address assignment method does not support failover protection. If the DHCPv6 server fails, hosts are unable to obtain an IPv6 address, and the network ceases to function. Furthermore, DHCPv6 does not provide gateway information. See RFC 3315 for more information.

In this example, Server-Fgt is connected to Client-Fgt. Server-Fgt has a stateful DHCPv6 server configured that allows Client-Fgt to automatically obtain an IPv6 address and DNS server address using the DHCP option.

To configure a DHCPv6 stateful server in the GUI:

1. Configure the Server-Fgt with DHCPv6 stateful server:

   1. Go to Network > Interfaces and edit port5.

   2. Configure the following settings:

      DHCPv6 Server	Enable
      IPv6 subnet	2001:db8:d0c:1::/64
      DNS service	Same as System DNS
      Stateful server.	Enable
      IP mode	IP range
      Address range	2001:db8:d0c:1::a to 2001:db8:d0c:1::f

   3. Click OK.

2. Configure Client-Fgt to obtain an IPv6 address using DHCP:

   1. Go to Network > Interfaces and edit port5.

   2. Set IPv6 addressing mode to DHCP.

   3. Click OK.

3. Verify that Client-Fgt obtained an IPv6 address and DNS server address from the DHCPv6 server:

   1. Go to Network > Interfaces and edit port5. The Obtained IP/Netmask and Acquired DNS fields are populated with an IPv6 address.

To configure a DHCPv6 stateful server in the CLI:

1. Configure Server-Fgt with DHCPv6 stateful server:

   config system dhcp6 server
       edit 1
           set dns-service default
           set subnet 2001:db8:d0c:1::/64
           set interface "port5"
           config ip-range
               edit 1
                   set start-ip 2001:db8:d0c:1::a
                   set end-ip 2001:db8:d0c:1::f
               next
           end
       next 
   end

2. Configure Client-Fgt to obtain an IPv6 address using DHCP:

   config system interface
       edit "port5"
           config ipv6
               set ip6-mode dhcp
           end
       next
   end

3. Verify that Client-Fgt obtained an IPv6 address and DNS server address from the DHCPv6 server:

   # diagnose ipv6 address list | grep port5
   dev=4 devname=port5 flag=P scope=0 prefix=128 addr=2001:db8:d0c:1::a preferred=4294967295 valid=4294967295 cstamp=1298969 tstamp=1298969ip6-address        
   # dia test application dnsproxy 3
   worker idx: 0
   VDOM: root, index=0, is primary, vdom dns is enabled, pip-0.0.0.0 dns_log=1
   dns64 is disabled
   DNS servers:
   2001:db8:d0c:1::ff:53 vrf=0 tz=0 encrypt=none req=1 to=1 res=0 rt=0 ready=1 timer=0 probe=0 failure=1 last_failed=19812