Address group exclusions

Specific IP addresses or ranges can be subtracted from the address group with the Exclude Members setting in IPv4 address groups.

This feature is only supported for IPv4 address groups, and only for addresses with a Type of IP Range or Subnet.

To exclude addresses from an address group using the GUI:

1. Go to Policy & Objects > Addresses.
2. Create a new address group, or edit an existing address group.
3. Enable Exclude Members and click the + to add entries.
4. Configure the other settings as needed.
5. Click OK.

   

   The excluded members are listed in the Exclude Members column.

   

To exclude addresses from an address group using the CLI:

config firewall addrgrp
    edit <address group>
        set exclude enable
        set exclude-member <address> <address> ... <address>
    next
end