Define an SD-WAN member
An SD-WAN link member is a target with a priority and weight clearly specified.
Use the following commands to define a link member.
CLI command |
Description |
---|---|
set target |
Specify the target to which traffic is forwarded. |
set health-check |
Specify the link health check of the VWAN. |
set priority |
Specify the priority of the link member. The valid range is 1–7. |
set weight |
Specify the weight of the member. |
Example SD-WAN member configurations:
The following example shows the configuration for two members (tunnel0
and tunnel1
) on top of interfaces fcs-0-phase-1
and fcs-1-phase-1
, respectively, and prefixed with a target. The same can be attained over any available interface type.
config system vwan_member
edit tunnel0
set target target.fcs-0-phase-1
set priority 1
set weight 1
set in-bandwidth-threshold 0
set out-bandwidth-threshold 0
set total-bandwidth-threshold 0
set health-check vwchk1
next
edit tunnel1
set target target.fcs-1-phase-1
set priority 1
set weight 1
set in-bandwidth-threshold 0
set out-bandwidth-threshold 0
set total-bandwidth-threshold 0
set health-check vwchk1
next
end