Status, diagnostics, and debugging commands

FortiExtender supports the following CLI commands for system status checking, diagnostics, and debugging.

Task	CLI command/action
Check connectivity to FortiGate	`get extender status`
Check connectivity to FortiExtenderCloud	`get cpm status`
Check the status of modems	`get modem status`
Perform health checks and monitoring	`get hmon hchk vwan.<vwan_member name>` (The member can be tunnel0 or tunnel1.)
Perform modularized debugging	Select the module. Turn the log level on/off as needed.
Debug	`execute debug <module> <log level> on/off`
Logs on telnet/ssh	`execute debug log-to-console on`
	`SYSTEM,MONITORD, EXTD, MDMD, CONNMGR,NETD,CLI,GUI CPM,CONFIG,JCLI,HMON,IPSecD,FIREWALLD`
Applicable log levels	`error, info, dbg, fatal, warning, trace`
Packet tracing	Start the tcpdump utility from the shell prompt using the command `execute shell.`

FortiExtender supports the following CLI commands for system status checking, diagnostics, and debugging.

Task

CLI command/action

Check connectivity to FortiGate

get extender status

Check connectivity to FortiExtenderCloud

get cpm status

Check the status of modems

get modem status

Perform health checks and monitoring

get hmon hchk vwan.<vwan_member name>

(The member can be tunnel0 or tunnel1.)

Perform modularized debugging

Debug

execute debug <module> <log level> on/off

Logs on telnet/ssh

execute debug log-to-console on

SYSTEM,MONITORD, EXTD, MDMD, CONNMGR,NETD,CLI,GUI CPM,CONFIG,JCLI,HMON,IPSecD,FIREWALLD

Applicable log levels

error, info, dbg, fatal, warning, trace

Packet tracing

Start the tcpdump utility from the shell prompt using the command execute shell.