Resolved issues
The following issues have been fixed in FortiSwitchOS 7.0.3. For inquiries about a particular bug, please contact Customer Service & Support.
Bug ID | Description |
---|---|
488900 | The processing load of background tasks needs to be reduced. |
724558 | A network outage is caused by the flash module of the FS-1048E failing. |
735913 | The Spanning Tree Protocol (STP) flaps on an FS-448DN, and roles are changed. |
741267 | After a user edits the physical interface in the GUI, clicking OK causes a “Request timed out. Please try again later.” error. |
741354 | The DHCP client module crashes with a signal 11 (segmentation fault) in a two-tier MCLAG network topology using managed FortiSwitch units. |
743749 |
After a third-party hub is disconnected and then connected, MAC Authentication Bypass (MAB) sometimes does not work. |
746584 |
The FS-448D stops responding after a random number of days. |
748177 |
When the network monitor is enabled, the MCLAG trunk becomes unstable. |
749315 |
The VLAN ID of a switch virtual interface (SVI) should not be the same as the native VLAN ID of a layer-2 internal interface. |
749744 | Setting the 10G moduleʼs speed to 1G should not cause error messages. |
752085 | When the switch receives a recordAgreement, the FS-1024D sends the bridge protocol data unit (BPDU) with the proposal bit on every 2 seconds. |
753630 | When the 802.1x port-based authentication daemon crashes, MAB does not function until the switch is restarted. |
754232 | The user is receiving “internal PS changes to good state” and “internal PS changes to bad state” warning messages. |
Common vulnerabilities and exposures
FortiSwitchOS 7.0.3 is no longer vulnerable to the following CVEs:
- CVE-2021-3711
- CVE-2021-3712
- CWE-190
Visit https://fortiguard.com/psirt for more information.