Configuring high availability
FortiIsolator supports high availability and A-A clustering. You can deploy devices in a cluster and distribute traffic using Round Robin or Weighted Round Robin load balancing. You can use the FortiIsolator UI or the FortiIsolator CLI to configure high availability.
|
It’s recommended that you use mgmt. interface for Cluster Settings, not internal interface. |
Configuring high availability in FortiIsolator UI
Steps
- From the administration portal, go to System > HA.
- Fill in the desired settings and click Apply to finish.
Configuring high availability in FortiIsolator CLI
Steps
- To configure high availability, use the following CLI commands:
- After you enable or disable high availability, you must restart FortiIsolator.
|
FortiIsolator High Availability CLI commands |
|---|
|
|
|
|
ha-lost-threshold [1-60]
|
ha-interval [1-20] in unit of seconds |
ha-hello-holddown [5-300] in unit of seconds |
ha-priority [0-255] where 255 means not used |
ha-allow-override 0/1
|
ha-schedule <schedule type>
|
ha-virtual-ip <IP/netmask> e.g. 192.168.100.2/24 |
|
|
|
|
|
|
