Configuring console
After the FortiIsolator starts up, use the default console to complete initial interface configuration. By default, the management interface on FortiIsolator (port3 on a VM installation) is set to 192.168.1.99.
The examples in this section are based on FortiIsolator VM. The process is similar for other FortiIsolator appliances, but interface settings can vary depending on the FortiIsolator model.
Finding the current settings
To find the current settings on FortiIsolator, type the show
command in the FortiIsolator CLI.
The following image shows an example of results from the show
command:
Setting the management IP address
To set the management IP address, type set mgmt-ip <ip_address>/<subnet_mask>
. For example:
> set mgmt-ip 192.168.1.214/24
Setting the management gateway address
To set the management gateway, type set mgmt-gw <subnet>/<gateway>
. For example:
> set mgmt-ip 0.0.0.0/0 192.168.1.254
All console commands
The following image shows the full list of console commands: