Enabling per-session accounting

You configure per-session accounting for the FortiGate, all NP7s in the FortiGate have the same per-session accounting configuration. Use the following command to enable per-session accounting:

config system npu

set per-session-accounting { disable | enable | traffic-log-only}

end

disable turns off per-session accounting.

enable enables per-session accounting for all traffic offloaded by the NP7 processor.

traffic-log-only (the default) turns on NP7 per-session accounting for traffic accepted by firewall policies that have traffic logging enabled.

Enabling per-session accounting can affect NP7 offloading performance.