Nortel ERS and Passport Switch
What is Discovered and Monitored
|
Protocol |
Information Discovered |
Metrics collected |
Used for |
|---|---|---|---|
|
SNMP (V1, V2c) |
Host name, software version, Hardware model, Network interfaces, |
Uptime, CPU and Memory utilization, Network Interface metrics (utilization, bytes sent and received, packets sent and received, errors, discards and queue lengths) |
Availability and Performance Monitoring |
|
SNMP (V1, V2c) |
Hardware status: Temperature |
||
|
SNMP (V1, V2c, V3) |
Layer 2 port mapping: associating switch ports to directly connected host IP/MAC addresses |
Identity and location table; Topology |
Event Types
There are no event types defined specifically for this device.
Rules
There are no predefined rules for this device.
Reports
There are no predefined reports for this device.
Configuration
SNMP
FortiSIEM uses SNMP to discover and monitor this device. Make sure SNMP is enabled for the device as directed in its product documentation. For more information, refer to sections "Discovery Settings" and "Setting Credentials" in the User Guide.
Settings for Access Credentials
Set these Access Method Definition values to allow FortiSIEM to communicate with your device.
| Setting | Value |
|---|---|
| Name | <set name> |
| Device Type | Nortel ERS / Nortel Passport |
| Access Protocol | See Access Credentials |
| Port | See Access Credentials |
| Password config | See Password Configuration |