Create or edit an SNMP user
Selecting Create New on the SNMP v3 table opens the New SNMP User page, which provides settings for configuring a new SNMP v3 user. Selecting a user name from the route list and selecting Edit opens the Edit SNMP User page.
Configure the following settings in the New SNMP User page or Edit SNMP User page and click OK:
|
User Name |
Enter the name of the user. After you create an SNMP user, you cannot change the user name. |
|
Enabled |
Toggle the slider to enable or disable this SNMP user. |
|
Security Level |
Select the type of security level the user will have:
|
|
Authentication Algorithm |
If the security level is set to Authentication and No Private, you can select MD5 or SHA1 for the authentication algorithm. If the security level is set to Authentication and Private, you can select AES, DES, AES256, or AES256 Cisco for the authentication algorithm. |
|
Password |
If the security level is set to Authentication, select Change and enter a password in the Password field. |
|
Hosts |
Settings for configuring the hosts of an SNMP community. |
|
IP Address |
Enter the IP address of the notification host. If you want to add more than one host, select + to add another host. Up to 16 hosts can be added. Select X to delete any hosts. |
|
Queries |
Settings for configuring queries for both SNMP v1 and v2c. |
|
Enabled |
Enable or disable the query. By default, the query is enabled. |
|
Port |
Enter the port number in the Port field (161 by default). |
|
SNMP Events |
Select the SNMP events that will be associated with the user. |