system snmp community
Use this command to configure simple network management protocol (SNMP) v1/2 settings.
These commands apply only if the SNMP agent is enabled. For details, see status {enable | disable}.
Syntax
config system snmp community
edit <index_int>
config host
edit <index_int>
set ip <address_ipv4>
set name <name_str>
set queryportv1 <port_int>
set queryportv2c <port_int>
set queryv1-status {enable | disable}
set queryv2c-status {enable | disable}
set status {enable | disable}
set trapevent {cpu | deferred-queue | ha | ip-change | logdisk | maildisk | mem | raid | remote-storage | spam | system | virus}
set trapportv1_local <port_int>
set trapportv1_remote <port_int>
set trapportv2c_local <port_int>
set trapportv2c_remote <port_int>
set trapv1_status {enable | disable}
set trapv2c_status {enable | disable}
end