system time ntp
Use this command to configure the FortiMail unit to synchronize its system time with a network time protocol (NTP) server.
Accurate system time is required by many features of the FortiMail unit, including but not limited to log messages and SSL-secured connections.
Alternatively, you can manually configure the system time of the FortiMail unit. For details, see system time manual.
Syntax
config system time ntp
set ntpserver {<address_ipv4> | <fqdn_str>}
set ntpsync {enable | disable}
set syncinterval <interval_int>
end
|
Variable |
Description |
Default |
|
Enter either the IP address or fully qualified domain name (FQDN) of an NTP server. You can add a maximum of 10 NTP servers. The FortiMail unit uses the first NTP server based on the selection mechanism of the NTP protocol. To locate a public NTP server, visit http://www.ntp.org/. |
pool.ntp.org |
|
|
Enable to synchronize the FortiMail unit with an NTP server, instead of manually configuring the system time. |
enable |
|
|
Enter the interval in minutes between synchronizations of the system time with the NTP server. The valid range is from 1 to 1440 minutes. |
60 |