Configuring the FortiLink interface
FortiLink connects switches (and APs) directly to FortiGate so that the network acts as a single device.
To configure the FortiLink interface:
- Go to Network > Interfaces, and double-click fortilink to open the interface for editing.
- Review the Interface members option. Do you see two members or no members?
Take one of the following actions:
- If you see two members, FortiLink is ready to connect to a switch. Note the port labels for the two members. The ports are likely labeled A and B, if they exist on your physical FortiGate.
- If you see no interface members, select the two physical LAN ports that were removed in the previous section. See Removing ports from the LAN hardware switch interface.
- Set the following settings in the Address section:
- Set Address mode to Dedicated to FortiSwitch.
- Enable Automatically authorize devices.
Devices can be manually admitted one at a time later if you wish.
- Disable FortiLink split interface. The split interface is used in scenarios where two or more switches are connected directly to a FortiGate.
- Enable DCHP server. The connected FortiSwitch will receive an IP address in this range.
- Click OK to save the FortiLink settings.