Configure the prefix-list which defines the prefix (IP address and netmask) for the filter of redistribution.

• prefix-name— for either static routes or connected routes

• id—rule-id (1-65535)

• action—permit/deny. Permit if it matches prefix network; deny if it does not match the exact prefix network.

• le—(less than or equal to). The le parameter can be included to match all more-specific prefixes within a parent prefix up to a certain length. For example, 10.0.0.0/24 le 30 will match 10.0.0.0/24 and all prefixes contained within a length of 30 or less.

• ge— (greater than or equal to) The length specified should be longer than the length of the initial prefix.

Configure route-map which defines the redistributed routes.

• route-map name—defines the route-map name

• rule—routing rule

• id—rule-id (1—65535)

• action— permit/deny. If set to permit, the system redistributes the permitted prefix-list; if set to deny, the system does not redistribute the permitted prefix-list.

• match-ip-address—Configure the prefix-list and identifies the prefix list defined in the prefix-list section.

  Note: Route-maps are numbered with edit IDs, which are sequential numbers such as 10, 20, etc. We recommend starting with Number 10 to reserve numbering space in case you need to insert new matched/denied condition in the future.

Configure router OSPF redistribute.

• status—enable/disable redistributing routes.

• metric-type—specify the external link type to be used for the redistributed routes. The options are E1 and E2 (default).

• metric value—used for the redistributed routes. The value range is from 1 to 16777214. The default is 10.

• routemap—defined and configured on the route-map, see Configure route-map for details.