Configure static routing

The table below describes the commands for configuring static routing.

CLI command	Description
config router static	Enters static route configuration mode.
edit <name>	Specify the name of the static route.
set status {enable | disable}	Set the status of the static route: enable—Enable the static route. disable—Disable the static route.
set dst <dst>	Specify the destination IP address and netmask of the static route in the format: x.x.x.x/x
set gateway <gateway>	Specify the IP address of the gateway.
set distance <distance>	Specify the administrative distance. The range is 1–255. The default is 1.
set device <device>	Specify the name of the outgoing interface.
set comment [comment]	Enter a comment (optional).

Example static route configuration:

config router static

edit 1

set status enable

set dst 0.0.0.0/0

set gateway 192.168.2.1

set distance 5

set device lan

set comment

next

End