Configure PBR routing

The table below describes the commands for configuring Policy Based Routing (PBR).

CLI Command	Description
config router target	Enters target configuration mode.
edit <name>	Specify the name of the target.
set interface <interface>	Specify the outgoing interface or tunnel.
set next-hop <next_hop>	Specify the IP address of the next-hop gateway .

Example PBR configurations:

config router target

edit target.lan

set interface lan

set next-hop 192.168.10.99

next

edit target.vwan1

set interface vwan1

set next-hop

next

Example PBR policy configuration:

config router policy

edit vwan1-pbr

set input-device /* Incoming interface name.

size[35] - datasource(s): system.interface.name

set src 192.168.2.0/24 /* Source IP and mask for

this policy based route rule.

set srcaddr /* Source address

set dst /* Destination IP and mask

for this policy based route rule.

set dstaddr /* Destination address

set service /* Service and service

group names.

set target /* This PBR's out-going

interface and next-hop.

set status enable /* Enable/disable this

policy based route rule.

set comment /* Optional comments. size

[255]

next

end