Monitoring health check status

FortiADC enables you to monitor the health of servers in real time directly from your desktop, as described below.

Before you begin:

• You must have already created a Health Check configuration.

To configure a health check monitor:

1. Click Shared Resources > Health Check.
2. Click the Health Check Monitor tab.
3. Configure the health check monitor as described in Checking server health.
4. Click Start to perform the health check. The result will show in the Monitor Information.

Checking server health

Parameter	Description
IP Address	Enter the IP address or FQDN of the remote server.
Health Check	Select the health check configuration.
Direct Route Mode	Enable/disable Direct Route Mode.
Real Server IP	Specify the IP address. Available only if Direct Route Mode is enabled.
Count	Specify the count. Range is 1 - 1000 (default = 1).
Interval	Specify the amount of time after the previous health check before this health check executes, in seconds (1 - 3600, default = 5).
Timeout	Specify the timeout period between health checks, in seconds (1 - 3600, default = 3).