Fortinet Document Library

Version:

Version:

Version:

Version:

Version:

Version:

Version:

Version:


Table of Contents

Handbook

Monitoring health check status

FortiADC enables you to monitor the health of server in real time directly from your desktop, as described below.

  1. Click Shared Resources > Health Check.
  2. Click the Health Check Monitor tab.
  3. Configure the health check monitor as described in Checking server health.
  4. Click Start to perform the health check. The result will show in the Monitor Information.

Checking server health

Parameter Description

IP Address

Enter the IP address of the remote server.

Health Check

Select the health check configuration.

Direct Route Mode

Enable/disable Direct Route Mode.

Real Server IP

Specify the IP address.

Available only if Direct Route Mode is enabled.

Count

Specify the count. Range is 1 - 1000 (default = 1).

Interval

Specify the amount of time after the previous health check before this health check executes, in seconds (1 - 3600, default = 5).

Timeout

Specify the timeout period between health checks, in seconds (1 - 3600, default = 3).

Monitoring health check status

FortiADC enables you to monitor the health of server in real time directly from your desktop, as described below.

  1. Click Shared Resources > Health Check.
  2. Click the Health Check Monitor tab.
  3. Configure the health check monitor as described in Checking server health.
  4. Click Start to perform the health check. The result will show in the Monitor Information.

Checking server health

Parameter Description

IP Address

Enter the IP address of the remote server.

Health Check

Select the health check configuration.

Direct Route Mode

Enable/disable Direct Route Mode.

Real Server IP

Specify the IP address.

Available only if Direct Route Mode is enabled.

Count

Specify the count. Range is 1 - 1000 (default = 1).

Interval

Specify the amount of time after the previous health check before this health check executes, in seconds (1 - 3600, default = 5).

Timeout

Specify the timeout period between health checks, in seconds (1 - 3600, default = 3).