Upgrading for FAP-U431/433F Support
You are required to download the FAP-U431/433F image file as it is NOT bundled in the controller image. Follow this procedure to download and install the FAP-U431/433F image.
Note: Direct upgrade to 8.6.0 can be done from releases 8.4.0 and above.
- Download the FAP-U431/433F image file from the remote server to the controller.
For example,
[FortiWLC controllers]
copy scp://download:download@<remote_server_IP>/<image_file_location>/forti-8.6-0build-04-patch-24102019120556-FAP43X-arm-generic-rpm.tar.fwlc
- Run the sh patch command to verify that the image file is copied successfully to the controller.
- Run the patch install <image filename> command to install the image file on the controller.
OR
Download the image file from the remote server and navigate to Maintenance > File Management > Patches > Import in the controller GUI.
- Select the imported image file and click Install. This step is required only if the auto-upgrade is disabled.
After the FAP-U431/433F image file is installed in the controller, run the upgrade ap same all command to upgrade the APs.