Deployment
To deploy a FortiVoice LSG unit in a branch office, review the tasks and perform the procedures in the following workflow:
|
To connect the phones to the network, make sure to follow the workflow in this section. With this workflow, the phones are assigned the correct configuration from the main office system. If you connect the phones too early in the workflow, then you will need to restore the phones to their factory default settings to remove the unassigned phone configuration that was retrieved from the branch office system. |
|
Before starting procedures in this guide, make sure to complete the basic setup of the primary and secondary FortiVoice phone systems and connect to the web-based manager of both systems. For more details, see the FortiVoice Phone System Administration Guide. |
|
Task sequence |
Description |
Procedure |
|---|---|---|
|
Perform tasks 1 to 5 on the FortiVoice LSG unit at the branch office. |
||
|
Task 1 |
Perform the following actions to complete the initial setup of the FortiVoice LSG unit:
|
|
|
Task 2 |
Connect to the web-based manager of the FortiVoice LSG unit. |
|
|
Task 3 |
Configure administrator and network settings on the FortiVoice LSG unit. |
|
|
Task 4 |
Upgrade the firmware of the FortiVoice LSG unit. |
|
|
Task 5 |
Change the deployment mode from PBX to survivability branch on the FortiVoice LSG unit. |
|
|
Perform tasks 6 to 9 on the FortiVoice phone system at the main office, as applicable. |
||
|
Task 6 |
Optionally, configure high availability (HA) on the primary and secondary FortiVoice units at the main office. |
Optional - Configuring high availability |
|
Task 7 |
Add or import branch extensions to the primary FortiVoice phone system at the main office. |
|
|
Task 8 |
Add a survivability branch to the FortiVoice phone system at the main office. |
|
|
Task 9 |
Apply the branch configuration from the main office FortiVoice phone system to the FortiVoice LSG unit at the branch office. |
|
|
Perform tasks 10 and 11 on the FortiVoice LSG unit at the branch office. |
||
|
Task 10 |
Verify that there is a healthy heartbeat between the FortiVoice LSG unit and the FortiVoice phone system. |
|
|
Task 11 |
Connect the phones to the network at the branch office. |
|
|
Branch paging (optional) |
||
|
If you want your FortiVoice LSG deployment to use paging, go to Branch paging. |
||