Starting a UDP Protocol SIP test

FortiTester tests UDP SIP by sending UDP frames with the specified SIP from the client ports to the server ports.

To start a UDP SIP test:

1. In Performance Testing, expand Protocol > UDP and click SIP.
2. Click Create New.
3. Configure the network or select a network template. See Using network configuration templates for how to create a network template.
4. Select a Certificate Group, if applicable.
5. Click OK.
6. Configure the test case options described below.
7. Click Start to run the test case.

FortiTester saves the configuration automatically so you can run the test again later. You can also click Save to save the test case without running it.

Tip 1: You can copy an existing case and change its settings to create a new case. In the case list, click Clone to clone the configuration. Only the case name is different from the original case. Tip 2: You can add or edit a comment when the test is running. This comment can be used to search for the test result in the Results page. This is useful especially when the test runs for a long time.

UDP SIP test case options

For details about the common options for protocol cases, see Protocol Test Case common options.

Settings	Guidelines
Client Profile
From	This field indicates the initiator of the request.
To	This field specifies the logical recipient of the request.
Re-Transfer Time	Select a time limit after which FortiTester will resend the data packet.
Retry Limit	Select the number of times FortiTester will attempt a transfer.