Discovering

This section covers the following topics:

• Authorizing
• Preparing the FortiSwitch unit

Authorizing

If automatic authorization is disabled, you need to authorize the FortiSwitch unit as a managed switch:

config switch-controller managed-switch

edit FS224D3W14000370

set fsw-wan1-admin enable

end

end

NOTE: After authorization, the FortiSwitch unit reboots in FortiLink mode.

Preparing the FortiSwitch unit

If the FortiSwitch unit is in the factory default configuration, it is ready to be connected to the FortiGate device. If the FortiSwitch unit is not in the factory default configuration, log in to the FortiSwitch unit with the CLI and use the execute factoryreset command to reset the FortiSwitch unit to the factory defaults