Editing a FortiAP profile
When you authorize a FortiAP unit, it is configured by default to use the default FortiAP profile (determined by model). The FortiAP profile defines the entire configuration for the AP.
From Edge Devices > FortiAPs under the FortiAP Profiles tab, you can create a new FortiAP profile or edit an existing default FortiAP profile.
Typically, you will edit an existing default FortiAP profile by selecting the profile and clicking Edit.
General FortiAP profile options
Field | Description |
---|---|
Name | Enter a name for the FortiAP profile |
Model | Select the FortiAP model to which this profile applies. Currently 431F or 231F |
Deployment Location | Select where the FortiAP is being installed either indoor or outdoor. You can override the default designation of the FortiAP to change the available channels based on your region. |
Country/Region | Select the country or region to apply the Country Code for where the FortiAP will be used. |
Login Password | Select if you want set a new AP login password or leave the password unchanged. |
Client load balancing | Select a handoff type as needed. See Wireless client load balancing for high-density deployments. |
802.1x authentication | Enable if you want to configure the FortiAP to act as a 802.1x supplicant to authenticate against the server using EAP-FAST, EAP-TLS or EAP-PEAP (see Configuring 802.1X supplicant on LAN). |
Radio-specific profile options
Field | Description |
---|---|
Mode |
Select the type of mode:
|
Band | Select the wireless protocols that you want to support. The available choices depend on the radio’s capabilities. Where multiple protocols are supported, the letter suffixes are combined: “802.11ax/n/g” means 802.11ax and 802.11n and 802.11g. |
Channel Width | Select channel width for 802.11ax or 802.11n on 5 GHz. |
Short Guard Interval | Select to enable the short guard interval for 802.11ax or 802.11n on 5 GHz. |
Channel Plan |
For 2.4 GHz radios, select if you want to automatically configure a Channel plan or if want to select custom channels.
|
Channels | Select the channel or channels to include. The available channels depend on which IEEE wireless protocol you selected in Band. By default, for 5 GHz radios all available channels are enabled. |
Transmit Power Mode |
Select how you want to determine transmit power:
|
Transmit Power | Specify either the minimum and maximum Transmit power levels in dBm or as a percentage. |
SSIDs | Select SSIDs to use for this radio either All or Specify with selected SSIDs added to a list. |
Monitor Channel Utilization | Select to enable monitoring channel utilization. |