Configuring an authentication rule
An authentication rule defines sources and destinations that require authentication and the authentication scheme applied.
To create or edit an authentication rule:
- Go to Policy.
- With the appropriate device selected, select Authentication Rules in the Policy type dropdown list.
- Click Create or select a policy and click Edit.
- In the form, enter the following information:
Settings
Guidelines
Name
Enter a name for the policy.
IPv4 Source Address
Select the IPv4 source addresses.
IPv6 Source Address
Select the IPv6 source addresses.
Protocol
Select the protocol this rule applies to.
Authentication Scheme
Select the authentication scheme to use. See Configuring an authentication scheme.
IP-based Authentication
Enable or disable IP-based authentication.
SSO Authentication Scheme
Select the authentication scheme to use for single sign-on.
This option is only available when IP-based Authentication is enabled.
Comments
Optionally, enter a comment for the policy.
- Click Save.