Auto-link setting is exposed to control configuration installation during ZTP 7.4.1
|
This information is also available in the FortiManager 7.4 Administration Guide: |
The auto-link setting is exposed in the model device wizard to allow administrators to better control configuration installation during the ZTP process.
To configure the auto-link setting for ZTP:
-
In the Add Model Device wizard, the option to Automatically Link to Real Device can be disabled or enabled.
-
The auto-link status is displayed in the Device Manager.
-
Auto-link can be enabled from the tool tip for single device, or by choosing multiple devices and selecting the Enable Auto-link setting in the More dropdown menu.
-
If for any reason auto-linking fails, you can try it again after the issue is resolved by clicking Retry Auto-link.
-
In the Add Model HA Cluster wizard, the option to Automatically Link to Real Device can be disabled or enabled.
-
After auto-linking is enabled, auto-link will be started after all cluster members are connected.
