Fortinet white logo
Fortinet white logo

Administration Guide

Enable or disable FortiAnalyzer features

Enable or disable FortiAnalyzer features

If FortiAnalyzer features are enabled, you cannot add FortiAnalyzer to FortiManager. Nor can you enable FortiManager HA.

When FortiAnalyzer is added to FortiManager, FortiAnalyzer features are automatically enabled to support the managed FortiAnalyzer unit, and cannot be disabled.

Note

Log forwarding, log fetching, and log aggregation are not supported on FortiManager when FortiAnalyzer features are enabled.

See Add FortiAnalyzer or FortiAnalyzer BigData for more information.

To enable or disable the FortiAnalyzer features from the GUI:
  1. Go to System Settings > Dashboard.
  2. In the System Information widget, click the FortiAnalyzer Features toggle switch.

    The FortiManager will reboot to apply the change.

To enable or disable the FortiAnalyzer features from the CLI:
  1. Log in to the FortiManager CLI.
  2. Enter the following commands:

    config system global

    set faz-status {enable | disable}

    end

Enable or disable FortiAnalyzer features

Enable or disable FortiAnalyzer features

If FortiAnalyzer features are enabled, you cannot add FortiAnalyzer to FortiManager. Nor can you enable FortiManager HA.

When FortiAnalyzer is added to FortiManager, FortiAnalyzer features are automatically enabled to support the managed FortiAnalyzer unit, and cannot be disabled.

Note

Log forwarding, log fetching, and log aggregation are not supported on FortiManager when FortiAnalyzer features are enabled.

See Add FortiAnalyzer or FortiAnalyzer BigData for more information.

To enable or disable the FortiAnalyzer features from the GUI:
  1. Go to System Settings > Dashboard.
  2. In the System Information widget, click the FortiAnalyzer Features toggle switch.

    The FortiManager will reboot to apply the change.

To enable or disable the FortiAnalyzer features from the CLI:
  1. Log in to the FortiManager CLI.
  2. Enter the following commands:

    config system global

    set faz-status {enable | disable}

    end