SD-WAN

In per-device management, you can configure SD-WAN directly on each device.

If you want to add BGP Neighbors to the configuration, you must create the BGP Neighbors first. See BGP Neighbors (per-device management).

To configure SD-WAN on a device:

1. Ensure that you are in the correct ADOM and that SD-WAN per-device management is enabled for the ADOM.
2. Go to Device Manager > SD-WAN > SD-WAN .
3. Click Create New in the content pane toolbar.

   The Create New SD-WAN pane opens.

   

4. Enter the following information, and click OK to :

   Device		Select the device to configure.
   SD-WAN Status		Select On or Off.
   Interface Members		Zones and interface members can be added, edited, and removed. See Zones and interface members (per-device management).
   Create VPN		See IPsec VPN Wizard (per-device management).
   Performance SLA		See Performance SLA (per-device management).
   Neighbor		See BGP Neighbors (per-device management).
   SD-WAN Rules		See SD-WAN rules (per-device management).
   Advanced Options		Configure the following advanced options:
   	fail-detect	Enable/disable fail detection features for this interface.
   	neighbor-hold-boot-time	Specify the interval.
   	neighbor-hold-down	Enable/disable neighbor hold down for this interface.
   	neighbor-hold-down-time	Specify the interval.

To edit an SD-WAN configuration:

1. If using ADOMs, ensure that you are in the correct ADOM.
2. Go to Device Manager > SD-WAN > SD-WAN .
3. Select the device from the list, and click Edit in the toolbar, or right-click the device and select Edit. The Edit page opens.
4. Edit the configuration as required, and click OK to apply your changes.

To delete an SD-WAN configuration:

1. If using ADOMs, ensure that you are in the correct ADOM.
2. Go to Device Manager > SD-WAN > SD-WAN .
3. Select the device from the list, and click Delete in the toolbar, or right-click the device and select Delete.
4. Click OK in the confirmation dialog box to delete the SD-WAN configuration.