archive journal
Microsoft Exchange servers can journal email and then send the journaled email to another server, such as FortiMail, for archiving.
Syntax
config archive journal source
edit <journal_source_id>
set comments
set email-archive-status {enable | disable}
set email-continuity-status {enable | disable}
set host
set recipient
set scan-status {enable | disable}
set sender
|
Variable |
Description |
Default |
|
Enter the ID of the journal. |
|
|
|
Enter general journal source comments. |
|
|
|
Enable or disable email archival of journal reports. |
enable |
|
|
Enable or disable email continuity, taking email from journal reports to users' mailboxes. When enabled, users can access inbound emails in instances where the email server protected by the FortiMail unit goes offline. Note: This command is only available when the FortiMail unit is operating in either gateway or transparent mode. |
disable |
|
|
Enter the ip address or host name of the journal source. |
|
|
|
Enter the recipient email address. |
|
|
|
Enable or disable scanning of embedded emails within journal reports. |
disable |
|
|
Enter the sender email address. |
|
|
|
Enable or disable the journal source. |
enable |