FortiIsolator appliance installation
Installing FortiIsolator 1000F
Use this procedure to install FortiIsolator 1000F.
Prerequisites
- Install FortiIsolator 1000F hardware, by following the instructions in the FortiIsolator 1000F QuickStart Guide.
- Download the FortiIsolator firmware, by following the instructions in Downloading FortiIsolator firmware.
- Connect to a console (for example, Tera Term).
Steps
- Using the console, load the FortiIsolator firmware file (for example, FIS_1000F-v1-build0084.out).
- Boot in to the FortiIsolator login. The default username is admin and there is no default password.
- Configure the network parameters (first time only). For example:
- Set the time zone.
- You can use the
showcommand to see the settings (for example, IP addresses, gateway address, DNS server information, and build number).
- You can use the
statuscommand to see system information (for example, build version, serial number, system time, disk usage, disk size, and sessions information).
- You can use the
helpcommand to see the FortiIsolator console comments.
