FortiIsolator appliance installation

Installing FortiIsolator 1000F

Use this procedure to install FortiIsolator 1000F.

Prerequisites

• Install FortiIsolator 1000F hardware by following the instructions in the FortiIsolator 1000F QuickStart Guide.

• Download the FortiIsolator firmware by following the instructions in Downloading FortiIsolator firmware.

• Connect to a console (for example, Tera Term).

Steps

1. Using the console, load the FortiIsolator firmware file (for example, FIS_1000F-v1-build0308.out).

   

   

2. Boot in to the FortiIsolator login. The default username is admin and there is no default password.

   

3. Configure the network parameters (first time only). For example:

   

4. Set the time zone (for example, use set timezone command to set time zone as PST8PDT).

   

5. You can use the show command to see the settings (for example, IP addresses, gateway address, DNS server information, and build number).

   

6. You can use the status command to see system information (for example, build version, serial number, system time, disk usage, disk size, and sessions information).
7. You can use the help command to see the FortiIsolator console comments.