Cellular interface of FortiGate-40F-3G4G supports IPv6 7.4.1
This information is also available in the FortiOS 7.4 Administration Guide: |
The cellular interface of FG-40F-3G4G devices supports IPv6.
config system lte-modem set pdptype {IPv4 | IPv6 | IPv4v6} end
pdptype |
Specify the Packet Data Protocol (PDP) for the cellular interface:
|
Example
In this example, PDP type is set to IPv4v6 in the wireless profile.
To use IPv4v6:
-
On FortiGate-40F-3G4G, use the
execute lte-modem wireless-profile
command to create or modify a wireless profile withpdptype
set toIPv4v6
. See the 3G4G LTE Modem Operator's Manual for details. -
List all profiles.
In the following example,
PDP_Type
is set to3
to indicate support for both IPv4 and IPv6.# execute lte-modem wireless-profile list ID Type Name APN PDP_Type Authen Username 1 0 ota.bell.ca 3 0 2 0 Bell ota.bell.ca 3 0 Profile Type: 0 ==> QMI_WDS_PROFILE_TYPE_3GPP Profile PDP type: 0 ==> QMI_WDS_PDP_TYPE_IPV4 1 ==> QMI_WDS_PDP_TYPE_PPP 2 ==> QMI_WDS_PDP_TYPE_IPV6 3 ==> QMI_WDS_PDP_TYPE_IPV4_OR_IPV6 Authentication: 0 ==> QMI_WDS_AUTHENTICATION_NONE 1 ==> QMI_WDS_AUTHENTICATION_PAP 2 ==> QMI_WDS_AUTHENTICATION_CHAP 3 ==> QMI_WDS_AUTHENTICATION_PAP|QMI_WDS_AUTHENTICATION_CHAP
-
Apply the correct profile.
In the following example, profile 2 is selected. The
apn
setting must also match theapn
setting in the selected profile.config sys lte-modem set pdptype ipv4v6 set force-wireless-profile 2 set apn ota.bell.ca end
-
Wait for the profile to take effect, and then check the data session information:
# diagose sys lte-modem data-session-info LTE Modem data session information: Interface name: wwan IPV4 connection: QMI_WDS_CONNECTION_STATUS_CONNECTED IPV6 connection: QMI_WDS_CONNECTION_STATUS_CONNECTED Profile ID: 2 Data profile name: Bell Profile type: QMI_WDS_PROFILE_TYPE_3GPP PDP context type: QMI_WDS_PDP_TYPE_IPV4_OR_IPV6 APN name: ota.bell.ca ------------------------------------- IP: 10.34.139.21 IP gateway: 10.34.139.22 IP netmask: 255.255.255.252 Primary DNS: 161.216.153.1 Secondary DNS: 161.216.157.1 MTU: 1500 Link protocol: QMI_WDA_LINK_LAYER_PROTOCOL_RAW_IP ------------------------------------- IPv6: 2605:b100:93b:cf64:bd33:e6ba:b2ef:5e58 IPv6 prefix len: 64 IPv6 gateway: 2605:b100:93b:cf64:60c8:e41d:be4b:eaf5 IPv6 GW prefix len: 64 IPv6 PRI DNS: 2605:b100:880:9::1 IPv6 SEC DNS: 2605:b100:680:9::1 MTU: 1500 Link protocol: QMI_WDA_LINK_LAYER_PROTOCOL_RAW_IP Auto connect: QMI_WDS_AUTOCONNECT_DISABLED Network type: Unknown WDS Bearer Tech Network type(last): Unknown WDS Bearer Tech
-
Verify IPv4.
In the following example, an IPv4 address is assigned to the wwan interface, and an IPv4 route is automatically added.
# diagnose ip address list IP=192.168.2.111->192.168.2.111/255.255.255.0 index=5 devname=wan IP=127.0.0.1->127.0.0.1/255.0.0.0 index=13 devname=root IP=169.254.1.1->169.254.1.1/255.255.255.0 index=17 devname=fortilink IP=192.168.1.99->192.168.1.99/255.255.255.0 index=18 devname=lan IP=127.0.0.1->127.0.0.1/255.0.0.0 index=19 devname=vsys_ha IP=127.0.0.1->127.0.0.1/255.0.0.0 index=21 devname=vsys_fgfm IP=10.34.139.21->10.34.139.21/255.255.255.255 index=23 devname=wwan FortiGate-40F-3G4G # get router info routing-table all Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2 i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area V - BGP VPNv4 * - candidate default Routing table for VRF=0 S* 0.0.0.0/0 [10/0] via 10.34.139.22, wwan, [1/0] C 10.34.139.21/32 is directly connected, wwan
-
Verify IPv6.
In the following example, an IPv6 address is assigned to the wwan interface, and an IPv6 route is automatically added.
# diagnose ipv6 address list dev=13 devname=root flag=P scope=254 prefix=128 addr=::1 preferred=4294967295 valid=4294967295 cstamp=2861 tstamp=2861 dev=19 devname=vsys_ha flag=P scope=254 prefix=128 addr=::1 preferred=4294967295 valid=4294967295 cstamp=5231 tstamp=5231 dev=21 devname=vsys_fgfm flag=P scope=254 prefix=128 addr=::1 preferred=4294967295 valid=4294967295 cstamp=5875 tstamp=5875 dev=23 devname=wwan flag=P scope=0 prefix=64 addr=2605:b100:93b:cf64:bd33:e6ba:b2ef:5e58 preferred=4294967295 valid=4294967295 cstamp=102181 tstamp=102181 dev=23 devname=wwan flag=P scope=253 prefix=64 addr=fe80::8049:4eff:fefc:ea5e preferred=4294967295 valid=4294967295 cstamp=102181 tstamp=102181 FortiGate-40F-3G4G # get router info6 routing-table database IPv6 Routing Table Codes: K - kernel route, C - connected, S - static, R - RIP, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2 i - IS-IS, B - BGP, V - BGP VPNv6 > - selected route, * - FIB route, p - stale info Timers: Uptime Routing table for VRF=0 S *> ::/0 [10/0] via 2605:b100:93b:cf64:60c8:e41d:be4b:eaf5, wwan, 00:09:20, [1024/0] C *> ::1/128 via ::, root, 00:24:50 C *> 2605:b100:93b:cf64::/64 via ::, wwan, 00:09:20