SD-WAN passive health check configurable on GUI 7.0.1
SD-WAN passive WAN health can be configured in the GUI.
By enabling passive health check in a policy, TCP traffic on that policy will be used in health check measurements.
To configure passive WAN health check in the GUI:
-
Go to Network > SD-WAN and select the Performance SLAs tab.
-
Edit an existing health check, or create a new one.
-
Set Probe mode to Passive or Prefer Passive.
-
Configure the remaining settings as needed.
-
Click OK.
The SLA list shows the probe mode in the Detect Server column, if the probe mode is passive or prefer passive.
|
Probe packets can only be disabled in the CLI and when the probe mode is not passive. |
To enable passive WAN health measurement in a policy in the GUI:
-
Go to Policy & Objects > Firewall Policy.
-
Edit an existing policy, or create a new one.
-
Set Outgoing Interface to an SD-WAN zone. Passive health check can only be enabled in a policy when the outgoing interface is an SD-WAN zone.
-
Enable Passive Health Check.
-
Configure the remaining settings as needed.
-
Click OK.